技术文章 - CS354780

在 Creo Parametric 中“创建新零件”或“打开”某些旧模型时出现“过早退出”

已修改: 12-Dec-2024   


注意:本文已使用机器翻译软件翻译,以方便非英语客户阅读。但翻译内容可能包含语法错误或不准确之处。请注意, PTC对本文所含信息的翻译准确性及使用后果不承担任何责任。请在 此处 查看本文的英文原始版本以便参考。有关机器翻译的更多详情,请单击 此处
感谢您告诉我们。我们将尽快审阅此译文。

适用于

  • Creo Parametric 7.0.5.0 to 7.0.6.0
  • Creo Parametric 8.0.0.0 to 8.0.2.0
  • Creo Parametric 6.0
  • This is a Creo Parametric Performance Advisor article
  • If this article was recommended to you from your dashboard, user(s) at your company have matched this exit and should implement the resolution
  • If you are not using the Performance Advisor for PTC Creo, read more about it here CS199298 and consider implementing it so you can get recommendations tailored to your Creo sessions and environment.
  • For Creo Parametric 7.0, issue not reproducible Creo Parametric 7.0.4.0 and earlier date codes 

说明

  • 创建新零件打开某些旧模型时过早退出
  • 创建新零件或打开某些旧模型时意外退出
  • 使用 Creo Worker 发布装配和绘图时意外退出
  • 无法打开或创建新的零件文件
  • 当用户尝试打开模型时 Creo Parametric 崩溃
  • 打开模型或图纸时,软件遇到致命错误
  • 打开新的或现有的图纸时过早退出
  • 打开小型部件时,软件意外退出,没有任何错误消息。
  • 安装 Creo 8.0.2.0 后,启动时出现 Auto-traceback Info 错误消息
  • 软件打开文件时出现致命错误
  • 保存新部件时,软件退出并显示 traceback.log 文件 每次我启动 Creo 7 并尝试打开任何文件时,都会出现回溯错误
这是文章 354780 的 PDF 版本,可能已过期。最新版本 CS354780