Article - CS208090
Creo View Adapters: Is it possible to publish the cross-hatching for 3D Model Cosmetic Sketches in Creo Parametric
Modified: 10-Jul-2025
Applies To
- Creo View Adapters 1.0 to 12.0
- Creo Parametric 1.0 to 12.4
- Creo View 1.0 to 12.0
Description
- Is it possible to publish the Cross-hatch for Creo Parametric 3D Model Cosmetic Sketches and Cross Sections
- Cosmetic Sketches are enabled using the following settings using the Creo View Recipe Editor: Basic > Required Entities: Datum Curves and Cosmetic Geometry
- Is there any additional configuration required to convert the Cosmetic Sketch Xhatch and Cross Sections?
- X-hatching are not available in the exported PVZ file and cannot be displayed in Creo View
- X-hatching displayed in combined states not visible in Creo View after exporting the 3D file as a PVZ file from Creo Parametric
- When a Creo Parametric combined view contains a cross section, after exporting the PVZ file, the hatching lines in cross section cannot be displayed after opening it in Creo View
This is a printer-friendly version of Article 208090 and may be out of date. For the latest version click CS208090