Article - CS31562
Options "update_drawing all" versus "enable_auto_drawing_update" and "auto_drawing_update" options in Creo Parametric
Modified: 10-Oct-2024
Applies To
- Pro/ENGINEER and Creo Elements/Pro Wildfire 2.0 M140 to Wildfire 5.0
- Creo Parametric 1.0 to 11.0
- Creo+
Description
- Is it possible and does it make sense to replace all the auto_drawing_update options in a config.sup with one line update_drawing all
- Does it make sense to activate update_drawing all and the above listed options at the same time
- What exactly will the option update_drawing and antiquate_drawing option do
- General benefit/damage of update_drawing all option.
- Does it make sense to activate the update_drawing all option permanently
- Why do old drawings in new releases behave and look different from newly created drawings
- A software correction for drawings is not working for existing drawings
- Some drawings display incorrectly, but it cannot be reproduced when recreating the drawing
- How can I make new drawings behave and look like old drawings
- How to apply drawing updates on retrieval
- Unable to retrieve drawing and add drawing updates when opened
- How to automatically apply a couple of update drawing values and prevent the users from setting additional values for the session
- The Break Hatching feature has no effect in notes in drawing mode
- Incorrect number of parts in the BOM table
- Cannot delete comments in drawings
- Specific drawing opens with errors for all users, but the assembly has no errors
- Errors are : !*** ERR: feat ### breaks group starting with feat ###
- Drawing also says regeneration was interrupted by errors
- Errors are : !*** ERR: feat ### breaks group starting with feat ###
- The drawing views are not getting updated.
- Unable to create balloons for an existing drawing which was created in previous release of Creo Parametric
This is a printer-friendly version of Article 31562 and may be out of date. For the latest version click CS31562