Article - CS57890
Unable to fully constrained a bolt in the assembly when a Coincident constraint is defined between the axes of the hole and the bolt and Coincident constraint is defined between the bottom face of the bolt and the top face of the plate in Creo Parametric
Modified: 10-Nov-2015
Applies To
- Creo Parametric 1.0 to 2.0
Description
- The bolt can not be fully constrained in the assembly when an Coincident constraint has been defined between the axes of the hole and the bolt and a Coincident constraint has been defined between the bottom face of the bolt and the top face of the plate.
- Constraint Orientation Assumptions.
This is a printer-friendly version of Article 57890 and may be out of date. For the latest version click CS57890