기술 문서 - CS300511

Integrity Modeler Connectors between blocks are not typed by their association block

수정한 날짜: 27-Jun-2022   


적용 대상

  • PTC Modeler 7.4 F000 to 9.5.0.0

설명

  • A connector between parts (or ports) instantiates an association and that association is defined by an association block the connectors type should be the association block.
  • Modeler is showing the associations name (default "Association") as the connector's type name even if an association block for the association exists
  • Unable to show the connector’s association block on the Internal Block Diagram
이는 기술 문서 300511의 PDF 버전이며, 구 버전일 수 있습니다. 최신 버전 CS300511